GL852G-60 is a full function solution which supports both Individual and Gang (4 ports as a group) mode for power management (Individual mode is only available in QFN28/LQFP48 package). are easily achieved by programming the external EEPROM or SMBUS mode. The complicated settings such as PID, VID, and number of downstream ports settings etc. GL852G-60 provides better design flexibility for customers. Default settings in the internal mask ROM is responded to the host without having external EEPROM. Firmware of GL852G-60 will control its general purpose I/O (GPIO) to access the external EEPROM and then respond to the host the customized PID and VID configured in the external EEPROM. GL852G-60 embeds an 8-bit RISC processor to manipulate the control/status registers and respond to the requests from USB host. GL852G-60 integrates both 5V to 3.3V and 3.3V to 1.8V low dropout voltage regulator into single chip, therefore no external LDO required. GL852G-60 provides multiple advantages to simplify board level design that help achieving lowest BOM (Bill of Material) for system integrator. GL852G-60 has proven compatibility, lower power consumption figure and better cost structure above all USB2.0 hub solutions worldwide. GL852G-60 inherits Genesys Logic’s cutting edge technology on cost and power efficient serial interface design. GL852G-60 is Genesys Logic’s advanced MTT hub solutions which fully comply with Universal Serial Bus Specification Revision 2.0.
